Short cycle times for storage and retrieval machines

Long cycle times, low loading capacity, stick-slip-effects, wear of steel tracks - these are only a few of the problems that occur when designing rollers and sliding elements for storage and retrieval machines.

We know these challenges from many conversations with customers, and after careful analysis, we have always worked out a joint solution. Whether we chose our LiNNOTAMDRiVE rollers for the chassis where we achieve twice the load capacity of commonly used plastics, or we worked with LiNNOTAM rollers for mast chassis, jack lifts and telescopic tables, where we achieved minimal wear as well as noise reduction when moving loads. The static and dynamic load capacity of rollers should not be a problem when handling and transporting small and large load
carriers. Also for this our LiNNOTAM line offered a practical solution.

With our selection of LiNNOTAM materials, especially for the application in storage and bulk material handling, we are able to achieve the best material characteristics for your requirement. Our application engineers work with you to design your parts, and the production is done by our in-house machining.

And another plus: You only have one contact person for the development of the material, the design of the part and the entire machining process. This saves you time consuming and sometimes cost intensive research into possible suppliers. At LICHARZ you receive everything from one source.

Give us a try!